- GENIUS G540 PROGRAMMER SOFTWARE INSTALL
- GENIUS G540 PROGRAMMER SOFTWARE DRIVER
- GENIUS G540 PROGRAMMER SOFTWARE CODE
GENIUS G540 PROGRAMMER SOFTWARE INSTALL
I don't have the programming adapter needed to connect to the microcontroller and reprogram it, and it's very likely that the flash is locked, preventing it from being read. One G540 Programmer One USB cable - One Install Software CD (user manual in it) One PLCC32-DIP32 socket. If anyone has any more information they can provide on this programmer, or is willing to experiment on one they own, it would be very helpful.
GENIUS G540 PROGRAMMER SOFTWARE DRIVER
As far as the software on the computer goes, all that is necessary to work with the programmer is to interface to the Silicon Labs USB driver included with the manufacturer's programming software. Description: This is Genius G540 USB universal programmer EPROM FLASH MCU GAL PIC BIOS SB Universal G540 EPROM FLASH MCU GAL AVR PIC Programmer Built-in 40 pin ZIF socket Is fully updatable via software link included in manual to software website Pin contacting detection: if IC and ZIF pins fail to connect. Genius G540 USB Programmer Software - LAB ONE Reprogramming The Genius G540 Chip Programmer Buying a G540 programmer I have been collecting old EPROM chips for many years.
GENIUS G540 PROGRAMMER SOFTWARE CODE
I'm not sure, but I'm assuming that all of the *.stg files are actually code for the microcontroller, and are uploaded to it through the USB interface when the selected device changes. It's in Chinese, so it might be hard to navigate) using a disassembler for the 8051, and it appears to contain some code used to test the functionality of the microcontroller. The programmer: The built quality is surprisingly high. Content of the Box: programmer, USB cable, QC card and a CD-R with the software on it. It came in a cardboard box and this were the contents. Hello, I just purchased a g540 programmer which said it can program the Atmel ATF22V10C chip. Perhaps one of its biggest short comings is the very poor standard of English, with many spelling and grammatical errors in the program. On a hunch, I decided to disassemble one of the *.stg files, specifically TestExe.stg, included with the programming software (which can be downloaded from the company's website. So I went to ebay an bought one of this widespread available Genius G540 ( ( G540 programmer on ebay )) EPROM programmers. The Genius G540 programmer is a case of good hardware let down by its software. It controls a CPLD and several shift registers, open collector buffers, and discrete transistors to manipulate the pins of the socket. From a quick look at the board, the entire programmer is controlled by a c8051f340 microcontroller, which is connected to the USB port.
This programmer supports more than 6000 chips.
This programmer is used for EEPROM flash 51 AVR PIC MCU SPI. Genius G540 USB programmer is a universal bios gal programmer. We are giving the software for G540 bios programmer for free. I have one of these programmers, and can tell you that while the software is definitely lacking features, including ones mentioned as part of the sales pitch, I think it has a lot of potential to be one of the most useful programmers available for under $60 if the exact way it works can be determined, and if new software were written to take advantage of it. Genius G540 Bios GAL Programmer Software free download.
0 kommentar(er)
